Copyright (C) 2017 Rohit Goswami [email protected]
This is the template for zenYoda rapid protoyping for presentations. The template comes with batteries included as it includes the dependencies for complete offline use.
Both pandoc style citations and traditional TeX citations are enabled, however keep in mind that TeX citations will not display in non-TeX files.
Read about the project at it's source here or on the documentation site here
For creating academic documents, refer to the sibling project, docuYoda and it's starter template.
Simply fork the repo.
Edit the slides.md file in src/md/slides/ and also slideConf.yml in src/ using any of the following:
You may use any of the pandoc markdown syntax, even if the viewers above do not support the entire syntax
You'll need to edit the Travis CI Settings for the repo as shown below:
- The first build WILL TAKE around ~20 minutes.
- Subsequent builds will only take around ~10 minutes or less.
- It's best to setup the CI immediately on forking the repository, then start working.
Simply clone the repo and follow the installation instructions once before
changing slideConf.yml and slides.md.
- Obtain tup.
- Obtain pandoc and pandoc-citeproc [usually these are in the same installation file].
- Obtain pipenv.
- Obtain yarn.
- Obtain direnv [OPTIONAL].
Once you get direnv you need to add the Python section from my .direnvrc
which goes in your $HOME directory.
After that just open a terminal and run the following:
pipenv install
yarn
# If you got direnv [recommended]
direnv allow
# Single compilation
tupYou can enable file watching by:
# Runs the monitor and automatically rebuilds on changes
tup monitor -a
# Stop the monitor
tup stopFor automatic reloading, get browsersync and run the following in another terminal:
# Get live reloading
yarn browser-sync sap -w --watchEvents addThe output is basically a SAP whoich may be deployed to Travis for posterity. (check the project docs)
Point your browser to the application.
For using Travis, change the site name in Travis. (more in the docs)
Apart from the yaml file switches, custom js for
revealjs may be added to
src/js/rjsConf.js. Also, custom scss rules for the same are to be put in src/scss/rjsOverrides.
This software is built on the following:
Additionally, for the site the following tools were used:
The site is built with:
Refer to the project license.
The project like much of pandoc itself is under the GNU GPLv3, however, please refer to the exceptions listed here.